|Home||» Products||» Fluid Mechanics (Combined Models)||» Vortex Orifice Reynolds Combined Apparatus|
Vortex Orifice Reynolds Combined Apparatus
FLUID MECHANICS (FM C003)
- ORIFICE AND MOUTHPIECE APPRATUS
- FREE FORCED VORTEX
- REYONLDS APPRATUS (HORIZONTAL VERTICAL)
Free Forced Vortex:-
This equipment is designed to produce and measure the characteristics of free and forced vortices. The apparatus comprises a clear acrylic cylinder on a plinth designed to produce and measure free and forced vortices. The free vortex is generated by water discharging through an interchangeable orifice in the base of the cylinder and the resulting profile is measured using a combined X-Y scale. The forced vortex is induced by a paddle in the base of the cylinder. The profile of the forced vortex is determined using a series of X-Y Probe.
Tank Diameter : 250 mm
Tank Height : 280 mm
Orifice Diameters : 8, 10 and 12 mm
Measurement Probe : Vertical and horizontal traveling pointer gauge
Drive: 180 W PMDC Motor
Orifice and Mouthpiece
This equipment permits calibration of orifices of differing diameters. In the orifice and free jet flow accessory a constant head tank will be fed with water from the common Sump. The orifice is installed at the base of the tank. The head will be maintained at constant value by an adjustable overflow pipe and will be indicated by a level scale. A jet trajectory tracing device allows the path followed by the jet to be ascertained.
Orifice Diameters : 10;12 and 14 mm
Mouthpiece 12 mm Nos.1
This accessory should be intended to reproduce the classic experiments conducted by Professor Osborne Reynolds concerning the nature of laminar and turbulent flow. The equipment operates in a vertical (or Horizontal) mode. A header tank containing stilling media provides a constant head of water through a bell mouth entry to the flow visualization pipe. Flow through this pipe is be regulated using a control valve provided at the discharge end. The flow rate of water through the pipe should be measured using the measuring cylinder. Velocity of the water can therefore be determined to allow calculation of Reynoldsâ€™ number.
The equipment uses a dye injection technique to enable observation of flow conditions.
Test Pipe : Acrylic, 25 mm dia., 500 mm long
Dye Reservoir : 500 ml